Faq's

What mark of motor is used?
Motor from manufacturer having CE & ISI mark
Does the motor a constant speed?
Yes, 1440 rpm.
It there any protection to the motor?
Yes, starter is fitted for the same. It prevents even single phasing care should be taken to set current in the relay as per requirement.
Is it possible to supply machine with single phase motor?
Yes, at extra cost..
Is the force mechanical or pneumatic?
Force is pneumatic using compressed air up to SRM – 12mm for higher size Hydraulic or Hydra pneumatic force.
What size of compressor is required?
As a thumb rule 06 – 1 hp compressor, 08 & 10 – 2 hp compressor & 12 – 3 hp compressor.
Is Compressor supplied with machine?
No, But can be supplied at extra cost.
What make of pneumatic cylinder is used?
Pneumatic cylinder is manufactured by us.
What make of pneumatic of is fitted on the machine?
JANATICS INDIA make pneumatics fitted on machine.
Is the control panel made in House?
Yes.
What make of Bearing is used?
We use Bearings SKF, NSK, ZKL, INA, IKO or NACHI as available.
What about ‘O’ rings & cup Seals? Are they available in the market?
These are proprietary items of manufacturer and need to be procured from us only.
How often these need to be replaced?
If lubricator in FRL unit works satisfactory these may to be replaced once in 3-4 years of running of the machine.
How often the oil need to be replaced?
The lubricator should be set such that a drop of oil goes for every year 15 – 20 strokes of the machine. Refilling of oil required once a week. However water in air collected in the filter should be drained regularly.